Guides / FAQ
3CX SIP trunk configuration
These are the generic steps only. Vendor-specific screens change often, so use the provider’s own 3CX guide for exact field values.
Facts last verified .
What are the basic steps to configure a SIP trunk in 3CX?
Add a new SIP trunk in the 3CX management console and choose the official provider template when one exists. Enter the registrar or IP details and the credentials from your provider, set the main trunk number, then create inbound and outbound rules.
What number format should the main trunk number use?
It depends on the provider. Some expect full international (E.164) format and others expect a national number, and the official 3CX notes differ by vendor. Follow the format your provider documents.
What should I test before going live?
Test inbound calls, outbound calls and outbound caller ID, and confirm that your emergency address is registered. Test emergency calling only by following your provider’s documented procedure.
Does it matter whether the PBX is hosted by 3CX?
Yes. The official 3CX directory pages advise registration-based trunks for systems hosted by 3CX, because the hosted public IP address can change. Check this before choosing a provider that requires IP authentication.
Where are the vendor-specific 3CX guides?
Several vendors publish their own. In our data, VoIP.ms has a 3CX configuration guide, SIP.US and Sinch have 3CX landing pages, IPComms publishes 3CX setup notes, and 3CX itself documents Wavix. Start from the official site linked on each provider page.